[Sep 25, 2021] 5V0-42.21 Dumps Full Questions - Exam Study Guide
VMware SD-WAN Design and Deploy 2021 Free Certification Exam Material from Actual4Dumps with 53 Questions
NEW QUESTION 24
A customer is looking to have Quality of Service (QoS), resource allocations, link/path steering, and error correction applied automatically based on applications.
Which component of VMware SD-WAN helps the customer achieve this requirement?
- A. High Availability Configuration
- B. Branch Site Topologies
- C. Overlay Flow Control
- D. Business Policy Framework
Answer: D
NEW QUESTION 25
A service provider assigns two Partner Gateways to a VMware SD-WAN Edge.
Which description is correct about default route.
- A. A default route 0.0.0.0/0 can be configured as a static route and set to NAT only on the Gateway
- B. When handoff is turned off on a Partner Gateway, the Gateway does not advertise a default route 0.0
0.0/0 to the Edge. - C. It default route 0 0 0.010 has been configured for both Gateways, internet traffic originated from the Edge can failover to the other Gateway in case of a Gateway failure.
- D. The service provider administrator decides whether the Partner Gateway advertises a default route
0.0.0.0/0 or not, although it is advertised by default.
Answer: A
NEW QUESTION 26
A customer is using VMware vSphere in their data center. An administrator is asked to deploy SD-WAN Edges for a Proof of Concept as soon as possible.
Which deployment option is the roost cost and time effective?
- A. Purchase bare metal Edge
- B. Deploy a virtual appliance in AWS
- C. Deploy a virtual appliance on ESXi
- D. Deploy a virtual appliance on KVM
Answer: D
NEW QUESTION 27
Which role(s) must be enable under Gateway configuration page to allow a VMware SD-WAN Gateway to build IPsec tunnels to non-VM SD-WAN?
- A. Control Plane + Data Plane + Partner Gateway
- B. Control Plane + Data Plane + SecureVPN Gateway
- C. Control Plane + Secure VPN Gateway
- D. Control Plane
Answer: A
NEW QUESTION 28
Which statement is true about the VMware SD-WAN Gateway roles and assignments?
- A. The SD-WAN Orchestrator assigns the Gateways to the Edge automatically when it comes up based Oil (lie location of the Edge Branch-to-branch will choose the right Gateway automatically
- B. Primary Gateway cannot be used as Super gateway for Edge-to-Edge communication, even it all the Edges have a common Primary gateway
- C. The Primarily and Secondary Gateways share the load fur both internet traffic and VPN traffic
- D. If the Primary Gateway goes down. Cloud internet traffic would failover to Secondary gateway automatically
Answer: B
NEW QUESTION 29
Which form factor can a customer use to deploy VMware SD WAN Edge?
- A. Hyper-V Virtual Machine
- B. Oracle Virtual Box
- C. Open Virtualization Appliance
- D. Docker Container
Answer: C
NEW QUESTION 30
An enterprise has deployed a VMware SD-WAN solution with Edges in many different located to different Partner Gateways.
Which design makes it possible to have dynamic branch to branch VPN tunnels between any two Edges?
- A. Configure each partner Gateway as a Controller.
- B. Dedicated at least one Gateway as a Controller, and few initial data plane packets will travers the Controller before dynamic tunnel is established between the two branches.
- C. Dedicate at least one Gateway as a Controller, and no data plan packets will traverse the Controller before dynamic tunnel is established between the two branches.
- D. Add Controller role to each Partner Gateway.
Answer: C
NEW QUESTION 31
Which statement is correct about VMware SD-WAN Orchestrator user roles and their associate privileges?
- A. Customer Support User can view and manage then company's network
- B. Standard Admin User can view but cannot manage their customer.
- C. Superuser: User can view but cannot create additional admin.
- D. Enterprise read only: User can view but not modify configurations.
Answer: A
NEW QUESTION 32
A service provider wants to offer a common service from its data center via VMware SD-WAN Partner Gateway to many customers with overlapping IP addresses.
Which configuration must be implemented?
- A. Enable tag type QinQ under hand off interface configuration
- B. Enable NAT hand off under hand off static routes configuration
- C. Configure source policy-based NAT under business- policies configuration
- D. Define multiple segments tor each customer
Answer: D
NEW QUESTION 33
A VMware SD-WAN customer has a requirement to enable single sign-on (SSO) authentication to their existing provider (idp) for access to their Orchestrator account.
Which authentication protocol is supported?
- A. LDAP
- B. TACACS+
- C. SAML 2.0
- D. OpenID Connect (OlDC)
Answer: C
NEW QUESTION 34
A customer is using hypervisor to install VMware Partner Gateways.
Which two hypervisors may be used? (Choose two.)
- A. ESXi
- B. XenServer
- C. KVM
- D. Hyper-V
- E. Kubermetes
Answer: C,D
NEW QUESTION 35
A customer is using VMware SD-WAN and has branches in different continents where the Edges are assigned with local Gateways.
Which Gateway should be used so all the branches can build tunnels with one another?
- A. Primary Gateway
- B. Alternate Gateway
- C. Regional Gateway
- D. Super Gateway
Answer: A
NEW QUESTION 36
What is considered a typical VMware SD-WAN use case?
- A. Provide high speed layer 2 data center interconnects.
- B. Provide management, control plane, and data forwarding from a single system to reduce complexly for the network administrator.
- C. Provide cloud delivered central management Orchestrator toimplementcomplex design network integration options.
- D. Provide a distributed (per device) commands line interface (CLI) based configurations to implement complex network designintegrationoptions.
Answer: B
NEW QUESTION 37
A service provider needs to upgrade a gateway to a new software version.
Which step in needed to complete the upgrade process?
- A. Create a new disk partition to save the new software image to, modify the boot order via the Gateway BIOS to boot to the new partition, and then reboot the gateway.
- B. Copy the new image to/var/lib/velocloud/software_update.tar, and then run the upgrade thescript from the console.
- C. Re-assign the Gateway to a new gateway Pool with the appropriate software version, and then run 'sudo apt-get update'' from the Gateway console.
- D. From the Orchestrator, select the check-box next to the appropriate gateway, choose ''Assign Software image", and then select the version for the upgrade.
Answer: A
NEW QUESTION 38
A MSP partner needs to setup a Partner Gateway and configure the Handoff Interlace.
Which are the valid configuration options for the Tag type?
- A. None, 802 1q, 802 3ad, and QinQ(0x8100) / QinQ(0x9100)
- B. None. 802. 1q. 802, 1 ad, arid QinQ(0x8100) / QinQ(0x9100)
- C. None, 802 1d, 802.1ad, and QinQ(0x8100)/ QinQ(0x9100)
- D. None, 802 1q. 802_1ac, and Qin(0x8100) / QinQ(0x9100)
Answer: B
NEW QUESTION 39
A customer would like to use a VNF firewall on the VMware SU-WAN 600 series Edge.
Where do the Edge firewallrules of the VNF apply?
- A. WAN side
- B. Underlay
- C. Overlay
- D. LAN side
Answer: A
NEW QUESTION 40
What Is a typical use case for the deployment of a VMware SU-WAN Partner Gateway?
- A. Provide mite transport m a service provider backbone tor interconnecting a global customer SD-WAN branches.
- B. Provide connectivity between multiple enterprise customers over private circuits
- C. Interconnect branches/remote sites of a single enterprise customer to the internet
- D. Get improved flow analytics for all traffic in the SD-WAN network
Answer: A
NEW QUESTION 41
......
Dumps Brief Outline Of The 5V0-42.21 Exam: https://www.actual4dumps.com/5V0-42.21-study-material.html
Use Real 5V0-42.21 - 100% Cover Real Exam Questions: https://drive.google.com/open?id=1fJ71EIChp_rXTxABeIaT1yQDuz9c7ID_